Philips SA4VBE08KF/37 - 13 Update Firmware via Philips Songbird; Firmware Update Process

36 EN
13 Update the
firmware
through Philips
Songbird
VIBE is controlled by an internal program called
ÀUPZDUH1HZHUYHUVLRQVRIWKHÀUPZDUHPD\
have been released after you have purchased
VIBE.
Through Philips Songbird, you can check for
DQGLQVWDOOÀUPZDUHXSGDWHVIRUVIBE over the
Internet.
Tip

<RXUPXVLFÀOHVDUHQRWDIIHFWHGE\DÀUPZDUHXSGDWH
1 Make sure that you have connected your
PCto the Internet.
2 Connect VIBE to the PC by using the USB
cable.
3 On the PC, launch Philips Songbird.
 If necessary, click Start > Programs >
Philips > Philips Songbird.
4 Click VIBE in the Player pane. Then, select
Tools > &KHFNIRUXSGDWHGÀUPZDUH in
the pop-up window.
» Philips Songbird checks for updates
DQGLQVWDOOVQHZÀUPZDUHIURPWKH
Internet, if available.
5 Follow the onscreen instructions.
» Downloading and installation of
ÀUPZDUHXSGDWHVWDUWDXWRPDWLFDOO\
» The VIBE UHVWDUWVDIWHUWKHÀUPZDUHLV
updated and is ready for use again.
Note

Wait until the update is completed, then disconnect the
VIBE from the computer.