Philips SimplyGo Quick Start Guide

Oxygen delivery modes
Pulse mode
When SimplyGo is in the Pulse mode, it detects when the user
begins to take a breath and then delivers a pulsed volume of oxygen
determined by the setting number.
Continuous Flow mode
In Continuous Flow mode, a constant flow of oxygen is supplied based
on the setting number (in liters per minute). When the desired mode
appears in the display, stop pressing the button and wait. The display
will return to the run time screen of the mode you selected and the
device will operate in this mode.
Sleep mode
Sleep mode is similar to the Pulse mode; SimplyGo detects when the
user begins to take a breath and then delivers a pulsed volume of
oxygen determined by the setting number. The Sleep mode differs
from Pulse mode in that it has a more sensitive triggering level and
delivers a softer, more comfortable pulse for sleeping. If no breath
is detected for a period of time, the system automatically delivers
a continuous flow of oxygen at a rate consistent with the last used
Continuous Flow mode setting.
3. Press down on the “PUSH” button located at the top
of the handle. Then pull the handle upward to extend
the cart arm to the desired height.
4. Attach the accessory bag around the cart handle using
the bag’s elastic strap.

Philips SimplyGo Specifications

General

Weight	10 lbs (4.5 kg) with battery
Dimensions	11.5 in x 10 in x 6 in (29.2 cm x 25.4 cm x 15.2 cm)
Operating Temperature	41°F to 104°F (5°C to 40°C)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Flow Settings	Continuous flow and pulse dose settings
Maximum Oxygen Output	2 LPM continuous flow
Power Source	AC, DC, or rechargeable battery
Operating Altitude	Up to 10, 000 feet (3048 meters)
Humidity Range	15% to 95% (non-condensing)
Charging Time	Approximately 2 to 3 hours