Philips STREAMIUM WAC7500 - Create Wired Connection with Automatic IP Address; Create Wired Connection with Static IP Address

12
To cycle through the alphanumeric
characters that are available, press a button
repeatedly.
T
o delete the last character entry from the
display, press CLEAR .
This
chapter shows you how to create a
wired connection to a home network with
automatic IP address.
1 Use an Ethernet cable (sold separately) to
connect the WAC7500 to the access point
or router that connects to your home
network with broadband Internet access.
2 Turn on your wireless access point or
wireless router with broadband Internet.
3 Turn on the WAC7500.
4 On the WAC7500, press MENU .
5 Select [Settings] > [Network] > [Wired]
> [Automatic] > (Apply settings?) [Yes]
and conrm.
The WAC7500 displays a conrmation
screen
that the settings are saved.
Create wired connection
with static IP address
This is how to navigate and select with the
remote control:
Press
or to select a menu option.
Press
to conrm a selection.
Press
to go back to the previous
screen.
Press
HOME to
go to the Home menu.
The alphanumeric buttons of the remote
control are multi-function buttons:
To select a number or an alphanumeric
character, press a button once or more
until you see the number or alphabetic
character in the display of the WAC7500.
To cycle through the alphanumeric
characters that are available, press a button
repeatedly.
To delete the last character entry from the
display, press CLEAR .
•
•
»
•
•
•
•
•
•
•
To delete the last character entry from the
display, press CLEAR .
This
chapter shows you how to create a
wireless connection to a home network
with static IP address.
1 Ensure that your encryption key (if
required) is available.
2 Turn on your wireless access point or
wireless router with broadband Internet.
3 Turn on the WAC7500.
4 On the WAC7500, press MENU .
5 Select [Settings] < [Network] >
[Wireless] and conrm.
6 Select the network from the list in the
display.
Enter encryption key (if required)
with
the remote control, then press
OK to
continue.
7 Select [Static] and conrm.
8 Enter the static IP address with the remote
control and conrm with OK .
9 Select (Apply settings?) [Yes] and conrm.
The WAC7500 displays a conrmation
screen
that the settings are saved.
Create wired connection
with automatic IP address
This is how to navigate and select with the
remote control:
Press
or to select a menu option.
Press
to conrm a selection.
Press
to go back to the previous
screen.
Press
HOME to
go to the Home menu.
The alphanumeric buttons of the remote
control are multi-function buttons:
To select a number or an alphanumeric
character, press a button once or more
until you see the number or alphabetic
character in the display of the WAC7500.
•
•
»
•
•
•
•
•
Connect to a home network
English
EN
wac7500_um_01eng.indd 12 14-08-08 16:29:43