To Next Page

To Previous Page

65BDL3652T/75BDL3652T/86BDL3652T

3.3.2. ID Remote Control

Set remote control ID number when using several displays.

Press the [ID] button and the red LED blinks twice.

1. Press [ID SET] button for more than 1 second to enter the

ID Mode. The red LED lights up.

Press the [ID SET] button again will exit the ID Mode. The

red LED lights o.

Press the digit numbers [0] ~ [9] to select the display to be

controlled.

For example: press [0] and [1] for display No.1, press [1] and [1]

for display No.11.

The numbers available are [01] ~ [255].

2. If no button is pressed within 10 seconds, it will exit from

the ID mode.

3. If a wrong button is pressed, wait for 1 second until the

red LED lights o and then turns on again, then press the

correct digits.

4. Press [ENTER] button to confirm your selection. The red

LED blinks twice and then lights o.

NOTE:

• Press [NORMAL] button. The green LED blinks twice,

indicating that the display is under normal operation.

• It is necessary to set up the ID number for each display

before selecting its ID number.

Philips T Line 65BDL3652T User Manual

Questions and Answers: