EasyManua.ls Logo

Philips TAR3306 - Product Specifications and Troubleshooting; Technical Product Information; Troubleshooting Common Issues

Philips TAR3306
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
EN
6
Product
information
Note
Product information is subject to change without prior
notice.
Rated Output Power 400mW RMS
Tuner (FM)
Amplier
Tuning Range 87.5-108 MHz
Tuning Grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio
<22 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
General information
AC Power (power
adaptor)
Brand: Philips
Model: AS030-
Input: 100-240V~
50/60 Hz; 0.15A
Output: 5V
0.6A
Operation Power
Consumption
<3 W
Standby Power
Consumption
<1 W
Dimensions
(W x H x D)
186 x 96 x 65 mm
Weight
(Main unit)
296 g
7
Troubleshooting
Warning
Never remove the casing of the product.
To keep the warranty valid, never try to repair
the device yourself. If you encounter problems
when using this device, check the following
points before requesting service. If the problem
remains unsolved, go to the Philips webpage
www.philips.com/support. When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
Make sure that the AC power plug of the unit
is connected properly.
Make sure that there is power at the AC outlet.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power plug,
then turn on the unit again.
Poor radio reception
Keep the clock radio away from other
electronic devices to avoid radio interference.
Fully extend and adjust the position of the
antenna.
Alarm does not work
Set the clock/alarm correctly.
Clock/alarm setting erased
Power has been interrupted or the power
plug has been disconnected.
Reset the clock/alarm.
Replace the backup batteries.
050-EE060

Related product manuals