2002 Jan 17 7
Philips Semiconductors Product specification
2 × 6 W stereo power amplifier TDA1517; TDA1517P
AC CHARACTERISTICS
V
P
= 14.4 V; R
L
=4Ω; f = 1 kHz; T
amb
=25°C; measured in Fig.6; unless otherwise specified.
Notes
1. Output power is measured directly at the output pins of the IC.
2. Frequency response externally fixed.
3. Ripple rejection measured at the output with a source impedance of 0 Ω, maximum ripple amplitude of 2 V (p-p) and
a frequency between 100 Hz and 10 kHz.
4. Noise voltage measured in a bandwidth of 20 Hz to 20 kHz.
5. Noise output voltage independent of R
s
(V
I
= 0 V).
SYMBOL PARAMETER CONDITIONS MIN. TYP. MAX. UNIT
P
o
output power THD = 0.5%; note 1 4 5 − W
THD = 10%; note 1 5.5 6.0 − W
THD total harmonic distortion P
o
=1W − 0.1 − %
f
lr
low frequency roll-off at −3 dB; note 2 − 45 − Hz
f
hr
high frequency roll-off at −1dB 20 −−kHz
G
v
closed loop voltage gain 19 20 21 dB
SVRR supply voltage ripple rejection note 3
on 48 −−dB
mute 48 −−dB
standby 80 −−dB
|Z
i
| input impedance 50 60 75 kΩ
V
no
noise output voltage
on R
s
=0Ω; note 4 − 50 −µV
on R
s
=10Ω; note 4 − 70 100 µV
mute note 5 − 50 −µV
α
cs
channel separation R
s
=10Ω 40 −−dB
|∆G
v
| channel unbalance − 0.1 1 dB
To Next Page
Loading...
