MAINTENANCE :
2
02.9663.0010 F 14-May-2009 27
Rear Head Assembly Removal
This procedure is necessary in order to access some components such as the gobo
wheel bulkhead and shutter assembly. Refer to as needed.
Tools:
#2 Phillips long handle screwdriver
To remove rear head assembly:
Step 1. Disconnect luminaire AC input cable from power source.
CAUTION: The rear head assembly is heavy and will remain attached by lamp wires.
Place luminaire on tech bench before removing rear assembly.
Step 2. At side rails, remove four 10-32x5/8" PPB screws and #10 split lock washers
(Figure 2-8). (Side rail spacers will come loose also.)
Step 3. Pull rear head assembly away from front head assembly.
Step 4. Re-install by doing steps 2 and 3 in reverse.
Figure 2-8: Rear Head Assembly Removal and Replacement
Rear Head Assembly
Front Head Assembly
10-32x5/8"
#10 Split
Lamp Wires
Yoke not shown for clarity.
NOTE:
Side Rail Spacer
PPB Screw
Lock Washer
To Next Page
Loading...
