Philips VL1000 AS - Tilt Encoder PCB Replacement

VARI❋LITE® - VL1000™ ERS LUMINAIRE SERVICE MANUAL
48 14-May-2009 02.9663.0010 F
Tilt Encoder PCB Replacement
Parts:
PCB ASSY, PAN/TILT ENCODER (24.9661.9629)
Tools:
#2 Phillips screwdriver
To remove and replace tilt encoder PCB:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove yoke leg cover (side with menu display) by removing four 6-32x3/
8" PTB screws.
Step 3. As shown in Figure 2-25, at tilt encoder PCB, remove two 4-32 screws.
Step 4. Disconnect connectors at J1 and J2.
Step 5. Remove encoder PCB.
Step 6. Replace encoder PCB by doing steps 2 through 5 in reverse.
Figure 2-25: Tilt Encoder PCB Replacement
4-32 Screw
Tilt Encoder PCB