Philips WAS7000 - Controls on the Station

12
English
2. Controls
2.1 Controls on the Station
(Top and front panels)
1
STANDBY-ON/ ECO POWER
– press briefly to switch the set on or to standby
mode;
– press and hold to switch the set to power-
saving mode or on
– Green indicator: lights up green when the
set is on
– Red indicator: lights up red when the set is
switched to standby mode or power-saving
mode
2 SOURCE
– selects sound source HD(hard disk), Radio,
USB, UPnP or AUX
– In standby mode: switches the set on and
selects sound source HD, Radio, USB,
UPnP or AUX
3 MUTE
– switches the sound off temporarily
4 1 / 2 / 3 / 4
–navigation controls (left, right, up, down) to
scroll through the option list
1
– HD/USB/UPnP: returns to previous option
lists
– Radio: enters the list of preset stations
3 / 4
– HD/USB/UPnP: skips/searches tracks/passage
backward/forward (in playback screen); fast
scrolls the option list
– Radio: tunes to radio stations
OK
– confirms selection
5 STOP
– stops playback
6 VOLUME -, +
– adjusts the volume level
7 IR
– sensor for the infrared remote control
Helpful hints:
– Always point the remote control towards this
sensor.
8 MUSIC FOLLOWS ME
– HD: moves music playback between Center
and Station or between Station and Station
MUSIC BROADCAST
– HD: broadcasts music from the Center to the
Station
DBB (Dynamic Bass Boost)
– turns the bass enhancement on
(DBB1, DBB2, DBB3) or off
INCR. SURROUND
– selects surround sound effect
VIEW
– toggles playback display and previous option list
– press and hold to view clock
9 SAME ARTIST
– HD: plays all the tracks of current Artist
– HD: enable Wireless Range Extender (refer to
Extender’s manual for details)
SAME GENRE
– HD: plays all the tracks of current Genre
SMART EQUALIZER
– HD: selects the matched sound setting for
current Genre
MENU
– enters or exits setup menu
0 Display
– shows status of the set
!
– jack for the external USB mass storage device
pg001-045_was7000_79 2006.12.7 9:56 AM Page 12