28
English
7.1 Tuning to radio stations
1
Connect the supplied FM wire antenna to the
Station (see 3. Installation)
2 Check that the set is switched on or in standby
mode (see 5. Basic functions)
3 Press SOURCE once or more times to select
Radio
➜ Playback screen appears. Display shows:
Radio, the radio station frequency and a preset
number (if already programmed)
4 Press and hold 3 or 4 until the frequency in the
display starts running.
➜ The radio automatically tunes to a station of
sufficient reception. Display shows Searching
during automatic tuning
➜ If a station is received in stereo, is shown
➜ When you are receiving an RDS station,
is shown
5 Repeat Step 3 if necessary until you find the
desired radio station
● To tune to a weak station, press 3 or 4 briefly
and repeatedly until optimal reception is
detected.
7.2 Storing preset radio stations
You can store up to 60 preset radio stations in
the memory.
7.2.1 Autostore: automatic programming
Autostore automatically starts programming
radio stations from Preset 1. Available stations
are programmed in the order of radio
frequencies: RDS stations followed by FM
stations. A maximum of 10 RDS stations will be
stored (from Preset 01 to Preset 10).
1 To select Autostore radio,
a. Press MENU
b. Use the navigation controls 3 or 4 and 2 to
select Autostore radio
➜ Display shows: Autostore Please wait...
➜ After all the stations are stored, the first
autostored preset station will then play
automatically.
7.2.2 Manual programming
1 Tune to your desired radio station (see 7.1
Tuning to radio stations).
2 Press PROGRAM on the remote control.
➜ The display shows:
INCR.SURR.
To Next Page
Loading...
