Philips WelcomeEye Connect 2 - SAFETY MEASURES; FCC;CE WARNING

F29
WelcomeEye Connect 2 / Touch / V4
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license. This product was manufactured and is sold by AVIDSEN SAS,
the sole guarantor of the product.
13. SAFETY PRECAUTIONS
Damage caused by failing to adhere to the manual nullies the warranty. We will not accept
liability for damage resulting from non-compliance!
We will not accept liability for any harm to goods or people caused by improper handling or
failure to adhere to safety instructions.
This product was manufactured in total compliance with safety guidelines. In order to
maintain this status and provide for the best possible conditions of usage, the user must
adhere to the safety instructions and warnings in this manual.
: This symbol indicates a risk of electrical shock or short-circuiting.
- Only use this product with electrical current in the following ranges: 100-240 volts and
50-60 hertz. Never attempt to use this device at a dierent voltage.
- Ensure that all the system’s electrical connections conform to the instructions for use.
- In commercial establishments, ensure that you adhere to the electrical installation
accident prevention regulations.
- In schools, training facilities, workshops, etc. qualied personnel must be on hand to
monitor electronic equipment operation.
- You must follow the instructions for use of any other devices connected to the system.
- Please contact an experienced person if you have any doubts regarding equipment
operation or safety.
- Never plug in or unplug electrical equipment with wet hands.
- When installing this product, check that the power supply cables are not at risk of being
damaged.
- Never replace damaged electrical cables yourself! In this case, remove them and call an
expert.
- The mains supply should be located close to the device and must be easily accessible.
- An easily accessible cut-o system (switch disconnector, circuit breaker, equivalent
system) must be integrated into the building’s wiring installation for the equipment
connected to the power grid.
- Keep a minimum distance around the device to guarantee sucient ventilation.
- Ventilation should not be blocked by covering the ventilation opening with an object such
as a newspaper, tablecloth or curtain, etc.
- No open ame source such as a burning candle must be placed on the device.
- Respect the product’s operating temperature.
- The device must not be exposed to liquid ow or splashing. Do not place any objects lled
with liquid such as vases on the device.
14. FCC/CE WARNING
Note: This equipment has been tested and found to be compliant with the limits of a Class
B device, according to European standards in force. These limits are designed to provide
reasonable protection against interference in a residential installation. This equipment
uses and may emit radio frequency energy and, if not tted and used according to the
instructions, may cause interference to radio communication.