Philips WelcomeEye Connect 2 - Monitor Installation

F7
WelcomeEye Connect 2 / Touch / V4
5) Using the badges:
To open the electric strike plate, quickly swipe your pre-programmed grey user badge on
the RFID reading eld. One short beep conrms the opening of the electric strike plate.
To open the gate motor, hold the badge in front of the RFID scan area for 3 seconds. Two
short beeps indicate that the gate is opening.
6) Replacing a badge
RFID badges do not have predened functions. It is the programming step that sets the
badge’s function. Badge colours simply enable users to recognize their functions. If a badge
is lost, it can be replaced by any other badge by repeating the programming step.
3. Installing the main or additional monitor
1m60
DES 9900 VDP
5 8 1 0 2 3
24V 550mA
+
-
1/3
2/4
WiĮ 2.4GHz
DES 9901 VDP
5 8 1 0 2 3
Made in P.R.C
Avidsen
19 avenue Marcel Dassault
37200 TOURS
FRANCE
1 2
4
7
5 6
3
1 - Position the wall bracket so that the screen of the monitor is approximately 1.60m above
the ground.
2 – Mark the location of the holes using the U bolt.
3 – Drill.
4 – Use pegs adapted to the bracket (those supplied are suitable for solid walls).
5 - Attach the wall bracket.