Philips WP3822 - Operating the Water Purifier: Filtered Spray; Using Filtered Spray Mode; Adjusting Filter Capacity Settings

Note: If you see another lter capacity on the display of your water purier,
press the lter capacity selection button again until the display shows the
capacity of your lter cartridge (2500, 1500 or 900 litres).The selected
capacity ashes for 4 seconds and is then shown continuously for another
5 seconds to indicate that the setting has been set.
Note: When you replace the lter cartridge for the rst time and any next
time, reset the lter capacity as described in section ‘How to reset the lter
capacity’ in chapter ‘Replacement’.
Using the appliance
1
Turn the water selection lever to the desired setting (‘click’).
The water selection lever has 3 settings: ltered spray, unltered spray
and unltered stream. See the sections below.
2 Open the tap.
Filtered spray
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1 Turn the water selection lever until the ltered spray symbol is
aligned with the indicator (Fig. 26).
Do not let water hotter than 50°C run through the water purier at
this setting, as this may damage the water purier.
If you lter water between 35°C and 50°C, the water may have an
unpleasant smell. The lter cartridge has absorbed this smell during
ltering, but releases it again if you lter water hotter than 35°C.
2 Open the tap.
Filtered spray comes out of the water purier.
The display is on and counts down the remaining lter capacity.
Note: The LCD display only shows the remaining lter capacity when you use
the water purier at the ltered spray setting and when the water pressure is
more than the minimum required 0.7kgf/cm² (7 meters of water column/
70kPa).
,
,
ENGLISH 13