Philips WP3822 - Troubleshooting Specific Problems; Weak Water Flow Troubleshooting; Display Issues Troubleshooting

Problem Solution
Perhaps the attachment nut or the tap-mounting
adapter is damaged. Contact an authorised Philips
service centre.
Perhaps the tap water pressure is higher than
specied.
You may need to wind some Teon tape around the
screw thread of the adapter.
The water
ow is weak at
the unltered
setting.
Perhaps the stainless steel screen under the rubber
washer inside the water purier housing is clogged.
Clean it with a soft brush and rinse it.
The water
ow is weak at
the ltered
setting.
Perhaps the lter cartridge is clogged. Replace the
lter cartridge.
Perhaps the tap water pressure is lower than
specied.
Perhaps you are using a lter cartridge whose
lifetime has expired. Replace the lter cartridge.
Air may be trapped inside the lter cartridge. This
may happen when you install a new lter cartridge.
To avoid this, slightly open the tap for 30 seconds
immediately after you install/replace the lter
cartridge. The slow stream of water removes any air
trapped in the lter.
The display
is empty after I
have replaced
the battery.
Perhaps the tap water pressure is lower than
specied.
ENGLISH 19