15
16. Roller Cleaning Function
1. First remove both the Safety Shield and Feed Table
2. Turn main power ON/OFF switch to OFF position
3. Press and hold the Reverse switch while turning the ON/OFF switch
back to ON
4. Release the Reverse switch
a. You will hear two audible beeps and the Power and Ready lights
will alternate on and off indicating the Cleaning mode
5. Use the reverse switch to rotate the rollers for cleaning
6. To return to normal operation, turn the main ON/OFF switch to OFF
7. Return Safety Shield and Feed Table to locked position
17. Stand By and Auto Sleep Functions
1. If the motor has been idle for Three (3) hours without running, the
machine will go into STAND BY mode. The temperature drops to
176° F and the ready light flashes.
a. To resume operation, press the MOTOR switch to the FWD position,
then back to the middle OFF positon.
b. Allow machine to reheat to proper temperature and Ready light
to illuminate solid.
2. If the motor has been idle for four (4) hours without running, the
machine will go into SLEEP mode, and the heaters are turned off.
a. To resume operation, press the ON/OFF switch to OFF position,
then back to ON and allow the ready light to come on.
18. Motor Switch Safety feature
1. Should the main ON/OFF switch be turned to OFF while the motor
switch is in FWD position, the motor must be reset to resume operation.
2. To reset the motor, turn the main ON/OFF switch to the ON position,
then turn the motor switch to the off or “0” positon, then to FWD when
ready to operate.
To Next Page