Phoenix Auto Equipment
-Address: 2711 East Craig Road Ste #E, North Las Vegas, NV, 89030 United States
- Website: https://www.phoenixautoequipment.com
- Phone: 7025802883
15 / 24
To begin, you must have a 15 or 14 inch steel rim with tire. If you don’t use
a 15 or 14 inch steel rim, the machine will not balance correctly. Install this
on the machine.
First, enter the wheel parameters then return to the initial balancing screen.
To enter the calibration process, do the following:
Push and hold down the FINE button for 3 seconds. The following
screen should appear:
Now close the plastic hood and spin the wheel. If you have the guard
control setting to “On” then the wheel will spin when the hood is
closed. If you have the guard control setting is set to “Off” then you
must push the START button to spin the wheel.
Let the wheel spin and come to a complete stop before opening the
plastic hood. The screen will then show the following:
Use your hand to rotate the tire until all 5 of the lights in the
OUTSIDE UNBALANCE POINT are on, as shown here:
To Next Page
Loading...
Need help?
General