Phoenix Auto Equipment
-Address: 2711 East Craig Road Ste #E, North Las Vegas, NV, 89030 United States
- Website: https://www.phoenixautoequipment.com
- Phone: 7025802883
19 / 24
Now place the 3.00 Ounce weight that came with the machine at 12
0’clock on the outside of the rim using the provided wheel hammer.
After placing the weight, close the hood and spin the wheel. The
following screen will appear:
You zeroed out both sides and successfully balanced the wheel.
Please note that the machine is showing the wheel is balanced within
the parameters you set in the system settings, specifically the “least
unbalance value setting”. In the above balancing example, my “least
unbalance value setting” was set to .70 ounces. After spinning the
wheel and placing the weight, any unbalance value remaining that
was less than .70 ounces was ignored and instead the machine
showed it zeroed out.
This is where the FINE button comes into function. At anytime while
balancing, you can press the FINE button to show the exact
unbalance value. The most accurate values are
1 gram or .10 Ounce using the FINE button. Please see the following
screen. This is the remaining unbalance value after the balancing
example shown above was performed.
To Next Page
Loading...
Need help?
General