Stand-Alone Mode
The Firey 808 can work independantly, without any
FireWire connection being established. The following
is just a couple of points of interest that you may need
to know to use the Firey in stand-alone mode.
Firstly, whatever settings you have made in regards
to inputs, outputs and sampling rates while using the
Firey 808’s mixer software will be kept even after
you restart the device and/or disconnect the FireWire
cable. This means whatever inputs and outputs you
have set will be activated/deactived as per your previ-
ous settings. The default sampling rate is 44.1 kHz,
and the default digital input/output is S/PDIF.
Also, the analog inputs are routed to their correspond-
ing analog outputs, as well as a mix of these inputs
being sent through any digital outputs that have been
set (ADAT, S/PDIF, etcetera).
To Next Page
Loading...
