9
FIREFLY 808
FireWire Interface
System Requirements
The following are the minimum required specications for use with the Firey 808. If your computer does not meet
these requirements, you will experience lagging of audio and possible freezing of your computer when attempting
to operate the mixer.
Windows
• Microsoft® Windows® XP SP1 and SP2 / Vista®
• Available FireWire port (suggested FireWire Interface: ADS Pyro 64 FireWire card with TI chip)
• Intel Pentium® 4 processor or equivalent AMD Athlon processor
• Motherboard with Intel or VIA chipset
• 5400 RPM or faster hard disk drive (7200 RPM or faster with 8 MB cache recommended)
• 512 MB or more of RAM (1 GB or more recommended)
Macintosh
• OS X 10.3.5 or later with native FireWire support
• G4 or newer processor
• 512 MB or more of RAM
Driver Installation
To use the Firey 808 on a PC, it is important to install all the necessary drivers from the included CD (ASIO and
WDM drivers). It is important that users read all instructions carefully before continuing on to the each step of
installation, as users will be required to unplug and plug in their FireWire device. These drivers are not necessary
for Mac users.
Windows XP (with Service Pack 1 or 2) / Vista
1. It is recommended that you quit all applications before starting the installation process.
2. Ensure the Firey is not yet connected to your Computer’s FireWire input.
3. Insert the installation CD included with your Firey into the CD-ROM drive of your computer. If the CD does
not automatically start the installation process within a few moments, then navigate to “My Computer” g your
CD-ROM drive g “Drivers and Control Panel” g double-click “setup.exe” to begin the installation manually. The
Phonic FireWire Control Panel software and the Firey 808 Mixer will also be installed at this time.
4. Follow the installation instructions.
Make sure no other programs are running on your PC and that the
Firey 808 is not connected to your PC, then click “Next”.
To Next Page
Loading...