Need help?Do you have a question about the Phonic PAA6 and is the answer not in the manual?
General| THD+N | < 0.1% |
|---|---|
| Frequency Range | 20Hz - 20kHz |
| Input Impedance | 10kΩ |
| Output Impedance | 100 Ohms |
| Display | LCD |
| Real Time Analyzer | 1/3 Octave |
| Measurement Range | 30dB - 130dB |
| Outputs | Line Output (3.5mm jack) |
| Type | Handheld Audio Analyzer |
| Inputs | Line Input (3.5mm jack) |
General safety precautions for operating the PAA6, including reading instructions, avoiding water, and proper cleaning.
Warnings regarding electrical shock, fire hazards, and proper product usage to prevent damage or injury.
Detailed guide to using the RTA function for spectrum analysis, including setup and measurements.
Guide to using the FFT function for detailed frequency response analysis with finer resolution.
Instructions for measuring reverberation time (RT60) in different environments.
Procedure for measuring Total Harmonic Distortion plus Noise (THD+N) in audio signals.
Using the Meter function for dB SPL, dBu, dBV, and Volt measurements with various input sources.
How to check the phase difference between two input signals using the Phase meter.
Using the Scope function to analyze audio waveforms for distortion, clipping, and polarity.
Guide to measuring Equivalent Continuous Noise Level (LEQ) over specified time periods.
Step-by-step guide for calibrating the PAA6's microphones using a sound level calibrator.
To Next Page