FEDERAL
COMMUNICATIONS COMMISSION
INTERFERENCE
STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is
no guarantee that interference will not occur
in
a particular
installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is
encouraged
to try to correct the interference by one or more
of
the
following measures:
- Reorient or relocate the receiving antenna.
-
Increase
the separation between the equipment and receiver.
-Connect
the equipment into
an
outlet on a circuit different from that to which the receiver
is
connected.
-Consult
the dealer or
an
experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could void the userls
authority to operate the equipment.
This device complies with Part 15
of
the FCC Rules.
Operation
is subject to the following
two
conditions:
(1)
This device may not cause harmful interference and
(2)
This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Warning
This equipment must be installed and operated
in
accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least
20
em from all persons and must not be co-located or operating
in
conjunction with any other antenna or transmitter. End-users and
installers
must be provided
with antenna installation instructions and transmitter operating conditions for satisfying
RF
exposure compliance.
Canada,
Industry
Canada
(IC) Notices
This Class B digital apparatus complies with Canadian
ICES-003
and
RSS-21
0.
Operation
is
subject to the following
two
conditions:
(1)
this device may not cause interference, and
(2)
this device must accept any interference, including interference that may
cause undesired operation of the device.
Radio Frequency (RF) Exposure
Information
The radiated output power of the Wireless Device
is
below the
Industry
Canada
(IC)
radio frequency exposure limits. The Wireless Device should be used
in
such a manner such
that the potential for human contact during normal operation
is
minimized.
This device has also been evaluated and shown compliant with the
IC
RF
Exposure limits under mobile exposure conditions. (antennas are greater than 20cm from a person
Is
body).
Canada,
avis
d'lndustry
Canada
(IC)
Get appareil numerique
declasse
B est conforme aux normes canadiennes
ICES-003
et RSS-21
0.
Son
fonctionnement est soumis aux deux conditions suivantes :
(1)
cet appareil
ne
doit pas causer d
1
interference
et
(2)
cet appareil doit accepter toute interference, notamment les
interferences qui peuvent affecter son fonctionnement.
Informations
concernant
l'exposition
aux
frequences
radio (RF)
La puissance de sortie
emise
par l'appareil de sans fil Dell est inferieure
a
Ia
limite
d
1
exposition aux frequences radio
d
1
1ndustry
Canada
(IC).
Utilisez l'appareil de sans
fil
de
fac;on
a
minimiser les contacts humains lors du fonctionnement normal.
Ce peripherique a egalement
ete evalue
et demontre
conforme aux limites d
1
exposition aux
RF
d
1
1C
dans des conditions
d
1
exposition
a
des appareils mobiles
(les
antennes
se
situent
a
moins de
20
em du corps
d
1
une
personne).
01
-31
-000003-01
To Next Page
Loading...
