Photron FASTCAM Mini GigabitEthernet Interface Connection Manual

9. Troubleshooting
39 GigabitEthernet Interface Connected Manual
ix. Check the following points when using the FASTCAM SA-X2/SA-Z.
Please note the following points regarding the LAN connection and the IP
address when using the Photron FASTCAM SA-X2/SA-Z high-speed
camera. Check the following points in addition to procedures i to viii.
 The FASTCAM SA-X2/SA-Z includes two Gigabit Ethernet interface
connectors. Note that the factory default for the IP address of
“GIGABIT ETHER2” is set to “192.168.1.10”.
 Confirm the LAN connection interface. The connection may not work
well or be unstable when connecting to the LAN with a PCI board,
PCMCIA card, or USB-LAN unit.
 The FASTCAM SA-X2/SA-Z can connect using two LAN cables. For
this reason, there are two IP addresses, but only one IP address
should be specified for the PFV connection setting. If both IP
addresses are specified, then they will be recognized as two separate
cameras.

Photron FASTCAM Mini GigabitEthernet Interface Specifications

General

Brand	Photron
Model	FASTCAM Mini GigabitEthernet Interface
Category	Digital Camera
Language	English