- Hold the tie rod manually so that it does not fall
into the fork leg and/or that both half-rings are not
in their position.
- Fit the bell.
- Tighten the nut until it stops.
- Act on the tool until the oil seal is completely re-
moved.
Specific tooling
020487Y Fork oil seal extractor
- Remove the hydraulic rod with the corresponding
sealing gasket, the spring and the stop bushing.
COMPONENT CHECK
CAUTION
CLEAN ALL THE COMPONENTS THOROUGHLY.
- Check that the fork leg is not cracked or broken
in the attachments.
- Check that the stem is not scored, dented or dis-
torted.
- Check that the stop bushing for the hydraulic rod
is correctly fixed through caulking.
Suspensions Beverly Tourer 250 i.e.
SUSP - 206
To Next Page