PIAGGIO Beverly Tourer 250 i.e. - Maintenance chart; Checking the spark advance

Maintenance chart
MAINTENANCE TABLE
●Replacement
■ Check
* Replace every 2 years
km x 1,000 1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80
Driven pulley roller casing (greasing) ■ ■ ■ ■ ■ ■ ■ ■
Safety locks ■ ■ ■ ■ ■
Ignition spark plug ● ● ● ●
Centre stand (lubrication) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Driving belt ■ ● ■ ● ■ ● ■ ●
Throttle control - (adjustment) ■ ■ ■ ■ ■ ■ ■ ■ ■
Air filter ■ ■ ■ ■ ■ ■ ■ ■
Oil filter ● ● ● ● ● ● ● ● ●
Valve clearance ■ ■ ■ ■
Electrical system and battery ■ ■ ■ ■ ■ ■ ■ ■ ■
Coolant level * ■ ■ ■ ■ ■ ■ ■ ■ ■
Brake fluid level * ■ ■ ■ ■ ■ ■ ■ ■ ■
Engine oil ● ■ ● ■ ● ■ ● ■ ● ■ ● ■ ● ■ ● ■ ●
Hub oil ● ■ ● ■ ● ■ ● ■ ●
Brake pads ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Sliding blocks / variable speed rollers ● ● ● ● ● ● ● ●
Tyre pressure and wear ■ ■ ■ ■ ■ ■ ■ ■ ■
Vehicle road test ■ ■ ■ ■ ■ ■ ■ ■ ■
Suspensions ■ ■ ■ ■ ■ ■ ■ ■ ■
Steering ■ ■ ■ ■ ■ ■ ■ ■ ■
Checking the spark advance
The ignition advance is determined electronically
on the basis of parameters known by the control
unit. For this reason it is not possible to interpret
the reference values based on the engine rpm.
The ignition advance value is detectable at any
time using the diagnostic tester. It is possible to
check whether the ignition advance determined by
the injection system matches the value actually
activated on the engine, by means of the strobo-
scopic light.
Proceed as follows:
- Remove the spark plug.
- Remove the plastic cover on the flywheel cover
shown in the photograph.
- Remove the transmission compartment air intake
cover shown in the photograph.
Beverly Tourer 250 i.e. Maintenance
MAIN - 29