PIAGGIO Beverly Tourer 250 i.e. - Air filter; Rear mudguard

Air filter
- Undo the two screws indicated.
- Reach the inspection compartment inside the
helmet compartment.
- Disconnect the two manifold clamps.
- Scollegare le tre fascette di collegamenti della
tubazione Blow-By.
Rear mudguard
- Loosen the 4 fixing screws, 2 of which are indi-
cated in the figure and the other 2 located on the
opposite side under the air filter;
- Remove the rear mudguard.
Beverly Tourer 250 i.e. Chassis
CHAS - 255