Refitting
- First grease the splitting chamber of the two seal-
ing lips of a new oil seal.
- Fit the sealing ring on the stem and keep the
identification words facing upwards.
- Drive the oil seal as far as it will go using the ap-
propriate tool.
Specific tooling
020376Y Adaptor handle
020359Y 42x47-mm adaptor
- Pre-fit the stem with the hydraulic rod, the spring
and the stop bushing.
- Fit the pre-assembled components inside the fork
leg.
- Fit the hydraulic rod fixing screw with the copper
sealing washer and tighten to the prescribed tor-
que using the recommended product.
CAUTION
ALWAYS USE NEW COPPER WASHER.
Locking torques (N*m)
Hydraulic rod fixing screw 25 ÷ 35*
(°) Apply LOCTITE 243 threadlock
- Lock hydraulic rod rotation using a 19-mm hex-
agonal spanner.
Suspensions Beverly Tourer 250 i.e.
SUSP - 208
To Next Page