PIAGGIO Beverly Tourer 250 i.e. - Aesthetic inspection; Tightening torques inspection; Electrical system

Carry out the listed tests before delivering the vehicle.
Warning- be very careful when handling fuel.
Aesthetic inspection
Appearance check:
- Paintwork
- Fitting of plastics
- Scratches
- Dirt
Tightening torques inspection
- Visually check that there is a yellow mark on the following clamps:
FRONT SUSPENSION
•
Front wheel pin nut
•
Screw fixing wheel pin on right fork leg
FRONT BRAKE
•
Screws fixing front brake callipers to fork
•
Brake pipes to front brake callipers couplings
REAR SUSPENSION
•
Rear wheel tightening screws
•
Shock absorber lower clamp
•
Upper shock absorber clamp
•
Swinging arm - engine retainer
•
Swinging arm - chassis retainer
•
Nuts fixing muffler supporting arm - engine
•
Screws fixing muffler to supporting arm
REAR BRAKE
•
Screws fixing rear brake calliper to supporting plate
•
Brake pipe / rear brake calliper coupling
•
Screws fixing the support plate to engine
STAND
•
Central stand bolt nuts
Electrical system
• Main switch
• Lights: high beams, low beams, side/taillights (front and rear) and relevant warning lights
Beverly Tourer 250 i.e. Pre-delivery
PRE DE - 261