Questa sezione descrive le operazioni da effettuare per lo smontaggio del motore dal veicolo.
Exhaust assy. Removal
- Remove the RHS footrest.
- Remove the Lambda probe from its support and
disconnect it.
- Cut the fastening clamp on the lambda probe ca-
ble.
- Undo the two exhaust manifold fixings on the
head. To unscrew the nuts that fix the muffler
flange to the head properly, use a jointed wrench
that allows, according to the travel direction, to get
also at the right nut. That is difficult to do with a
traditional straight wrench.
- Undo the three screws that fix the muffler to the
support arm.
- Remove the full muffler unit.
Engine from vehicle Beverly Tourer 250 i.e.
ENG VE - 88
To Next Page