- Insert the by-pass valve.
- Place a new crankcase gasket.
- Couple the crankcases, paying particular atten-
tion to avoid accidental movements during inser-
tion of the crankcase half which could cause
collision with the oil pump control toothing on the
crankshaft and, consequently, damage the bush-
ings.
- insert the crankcase fastening screws and tighten
it them to the specified torque.
Locking torques (N*m)
Engine-crankcase coupling screws 11 ÷ 13
Engine MP3 400 hpe E5
ENG - 110
To Next Page
Loading...
