When additional keys are required, please note that data storage (up to 7 keys max.)
must be done on all keys, both new and existing ones.
Take the red handgrip key and all the black keys supplied to an Authorised Piaggio
Service Centre.
The codes of keys not submitted for the new programming procedure are deleted from
the memory. Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF OWNERSHIP OF THE VEHICLE IS TRANSFERRED TO ANOTHER PERSON,
THE KEY WITH THE RED GRIP (AS WELL AS THE OTHER KEYS) AND THE
"CODE CARD" MUST BE ALSO TRANSFERRED TO THE NEW OWNER.
Programmingtheimmobilizersystem
Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
ISER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to «RUN».
Procedurestart-redkey
Insert the red ignition key in the switch key (in "OFF" position) and turn it to "ON". After
1 - 3 seconds, turn the key to «OFF » again and pull it out.
16
To Next Page
Loading...
