PICO PicoScope 3204A Programmer's Guide

PicoScope 3000A Series Prog rammer's Guide 75
Copyright © 2011-2013 Pico Technology Limited. All rights reserved. ps3000abpg.en r9
2.12.46
ps3000aSetEtsTimeBuffers
PICO_STATUS ps3000aSetEtsTimeBuffers
(
short handle,
unsigned long * timeUpper,
unsigned long * timeLower,
long bufferLth
)
This function tells the driver where to find your application's ETS time buffers. These
buffers contain the timing information for each ETS sample after you run a block-mode
ETS capture. There are two buffers containing the upper and lower 32-bit parts of the
timing information, to allow programming languages that do not support 64-bit data to
retrieve the timings.
Applicability
ETS mode only.
If your programming language supports 64-bit data then you can use
ps3000aSetEtsTimeBuffer instead.
Arguments
handle, the handle of the required device
* timeUpper, an array of 32-bit words, each representing the
upper 32 bits of the time in picoseconds at which the sample was
captured
* timeLower, an array of 32-bit words, each representing the
lower 32 bits of the time in picoseconds at which the sample was
captured
bufferLth, the size of the timeUpper and timeLower arrays
Returns
PICO_OK
PICO_INVALID_HANDLE
PICO_NULL_PARAMETER
PICO_DRIVER_FUNCTION

PICO PicoScope 3204A Specifications

General

Brand	PICO
Model	PicoScope 3204A
Category	Test Equipment
Language	English