Need help?Do you have a question about the Pike MIRacle ATR and is the answer not in the manual?
General| Compatibility | FTIR Spectrometers |
|---|---|
| Angle of Incidence | 45 degrees |
| Type | ATR (Attenuated Total Reflectance) Accessory |
| Crystal Material | ZnSe |
| Pressure Device | Pressure clamp with torque knob for consistent pressure |
| Applications | Liquid and Paste Samples |
Features a digital meter for precise pressure control.
Standard clamp for high pressure applications.
Offers precise pressure adjustment via a micrometer screw.
Placing the accessory correctly in the FTIR sample compartment.
Securing the accessory to the FTIR base plate.
Ensuring the accessory is ready for optical alignment.
Adjusting mirrors for maximum throughput using thumbscrews.
Adjusting mirrors for maximum throughput using hex wrench.
Collecting an open beam background spectrum.
Collecting a spectrum of the MIRacle ATR.
Table of micrometer settings and approximate pressures.
Step-by-step guide for using the micrometer clamp.
Steps to install the high-pressure clamp onto the accessory.
To Next Page