21
Step for parameter setting:
1. In any real-time data inquiry interface,
press button, enter into
configuration mode
2. Press button once, the single digit
flash for enter password
3. Press button once, to change the
single digit to 1 (default password is 1 )
Input password
1. Press button until it display A
2. Press button once, then the data
bit flash
3. Press button once to modify value
4. Press button once to confirm the
new value
Set communication address
1. Press button until it display b
2. Press button once , the value
flash
3. Press button once to modify baud
rate
4. Press botton once to confirm the
new baud rate
Set communication baud rate
1. Pree until it display I
2. Press button once , the value flash