Pilot Communications EGO700

Questions and Answers

J
jeremy99Aug 12, 2025
Why are the measurements incorrect on my Pilot Communications Measuring Instruments?
- Y
  yloweAug 12, 2025
  If the measurements on your Pilot Communications Measuring Instruments are incorrect, several factors could be at play: * **Incorrect Voltage Measurement:** Ensure the neutral connection is reliable, the measured voltage matches the equipment's rated parameters, and the PT variable ratio parameter is set correctly. * **Incorrect Current Measurement:** Verify the measured current aligns with the equipment's rated parameters and that the CT variable ratio parameter setting is correct. * **Incorrect Power Measurement:** Confirm the measurement mode settings are correct, the voltage and current phase sequence is correct, and the current namesake terminal is not incorrectly connected.
T
thomashernandezAug 20, 2025
What to do if the upper machine cannot communicate with Pilot Communications Measuring Instruments?
- L
  lwaltersAug 20, 2025
  If your upper machine is unable to communicate with the Pilot Communications Measuring Instruments, consider the following: 1. **Device Address:** Ensure the device address is consistent with the defined address. 2. **Communication Rate:** Verify the device communication rate matches the defined rate. 3. **Terminal Resistance:** Check if a 120-ohm resistance is added to the communication link. 4. **Communication Shield:** Confirm the communication shield is well grounded to minimize interference. 5. **Communication Line:** Check whether the communication cable is disconnected.
D
Desiree KnappAug 27, 2025
How to fix a Pilot Communications Measuring Instruments device with no display after powering on?
- C
  Casey ClarkAug 27, 2025
  If your Pilot Communications Measuring Instruments device has no display after applying power: * First, check that the correct operating voltage is applied to the L/+ and N/- terminals. * Second, verify that the control power fuse is not burnt out.
M
Michael HooverSep 4, 2025
What to do if the switch state does not change on Pilot Communications EGO700?
- E
  Emma ScottSep 4, 2025
  If the switch state on your Pilot Communications Measuring Instruments isn't changing, it might be due to an incorrect switch voltage. Check that the external node type matches the device rating parameters and that the external wiring is correct.