Pilz PSEN opII3H Series - Orientation; General Guidelines

Installation and alignment
Operating Manual PSEN opII3H Series
1003503-EN-08
| 34
6.2 Orientation
6.2.1 General guidelines
For the safety light curtain to function properly, the transmitter and receiver must be aligned
correctly.
The safety light curtain's transmitter and receiver can be aligned with or without a laser
alignment tool.
} Alignment with laser alignment tool: the safety light curtain does not need to be switched
on
} Alignment without a laser alignment tool: the safety light curtain must be already wired
(see Wiring) and switched on
For alignment Pilz recommends the PSEN opII Laserpointer (see Order references for
accessories [ 70]).
[3]
[1]
[2]
Fig.: Transmitter/receiver modification directions during orientation
Legend
[1] Vertical: by vertical shifting of position in the elongated holes in the top and bottom
flexible brackets
[2] Horizontal: by moving up and down in the slots in a horizontal direction
[3] The axis orientation can be changed by rotating the flexible bracket right or left
Pilz recommends that modifications to the orientation of the transmitter/receiver be made in
the following sequence:
1. Vertical modification
2. Horizontal modification
3. Axis orientation modification