Hunter-Pro Series Captain 8 - Installation Guide
66
The event that triggers it
Alarm in a “Panic” zone, or pressing the panic key combination
[*]+[#].
Alarm in a “Silent Panic” zone
Alarm in a “Hold-Up (Duress)” zone, or entering the
“Duress” code
Alarm in a “Medical” zone
Triggering an audio module: MIC-200 or VU-20N/U
Opening a zone (regardless of the panel status)
Zone is bypassed by a user
Resetting smoke/fire detectors
Opening a tamper switch (connected via TMPR1/TMPR2
terminals)
Opening a zone tamper, or a zone failure
Activating the "Buzzer" output type
Arming the panel to any mode
Entering the Installer code
AC, Low battery or Phone line faults occur
Communication fault occurs
Pressing the [*] button in a remote control
1
Activating an output by telephone
This output type is triggered upon receiving an ACK from the
Monitoring Station
The assigned output is triggered for 20 sec. (not programmable)
Opening a “Chime” zone. This can be used for a second
indication, e.g., speaker, another buzzer, etc.
The net4pro module failing to communicate with the Monitoring
station (including retries). The allocated output will be triggered
for 5 sec. (not programmable)
I.e., triggering an output.
To Next Page
Loading...
Need help?
General
