Key #2: Zones
49
Partition name are displayed only on supervised keypads
5.6. Copy zone
This feature allows you to copy the settings of a zone's to other zones. It is very useful during the
installation process: once programming a single zone, you can save time by copying its settings to
any other zone.
To copy a zone’s settings:
1. Select the “Source” zone, from which the settings will be copied.
2. Select the “Target” zones, to which the settings will be copied.
3. Select what to copy in the T-C-P screen. See the following table for details.
4. Wait for the message “Copying Finished”.
5. Press [END].
Copy options
To Next Page
Loading...
