Pioneer F-225L User Manual

FM/AM DIGITAL SYNTHESIZER TUNER
Operating
Instructions
F-225L/F-225
@PIONCER
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe place
for future reference.
in some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the
explanatory drawings. However, the method of connecting and
operating the unit is the same. .
WARNING :1o prevent FIRE OR SHOCK HAZ-
ARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
tanty card and keep it in a secure area. This is for your
security.
[For Canadian model]
CAUTION:10 prevent ELECTRIC SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION:pour prevenin Les cHocs
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU
UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Austra-
lian models are not provided with this switch.
Mains voltages in Saudi Arabia are 127V and 220V
only. Never use this mode! with 110V setting in
Saudi Arabia.
The tine voltage selector switch is on the rear panel. Before your
modei is shipped from the factory, this switch is set to the
power requirements of the destination. Check that it is set
properly before plugging the power cord into the AC wail
socket. If the voltage is not properly set or if you move to an
area where the voitage requirements differ, adjust the selector
switch as follows.
1. Use a medium-size screwdriver.
2. insert the screwdriver into the groove on the voltage
selector, and adjust so that the tip of the arrow points to the
voltage value of your area.
‘ ~
Set the voltage selector
r the voltage in your area.
fo
'
y'
A
Medium-size
screwdriver
YQ
PIONEER’
The future of sound and vision.

Pioneer F-225L Specifications

General

Tuning Bands	FM, MW, LW
Signal to Noise Ratio (FM)	70 dB
Signal to Noise Ratio (AM)	50 dB
Distortion (FM Mono)	0.3%
Distortion (FM Stereo)	0.5%
Output (FM)	650mV
Output (MW)	150 mV
Output (AM)	150 mV
Power Supply	AC 220-240V, 50/60 Hz
Type	Stereo Tuner
FM Tuning Range	87.5 to 108 MHz
MW Tuning Range	522 kHz - 1611 kHz
LW Tuning Range	153 to 281 kHz
Frequency Response (FM)	30 Hz - 15 kHz