18
En
02
Install Your Flat Panel Display
Follow the steps below to secure your flat panel display.
1 ) Mark locations for metal fittings and screws on the back edge of the table using the panel stand to determine
placement.
2 ) Drill holes in the table or platform edge at the marked locations.
3 ) Lift panel into place with the assistance with at least one other person.
4 ) Use wood screws (not included) to secure the metal fittings to the table.
(KRP-600M)
20 mm
(13/16 inch)
min.
8 mm to 15 mm
(3/8 inch to 5/8 inch)
4 mm
(5/32 inch)
Falling prevention
metal fitting
(supplied with the
optional stand)
Wood screw
(commercially
available,
4 mm x 20 mm
(5/32 inch ×
13/16 inch)
min.)
Chapter_02.fm Page 18 Thursday, June 19, 2008 2:54 PM
To Next Page
Loading...
