Pioneer PD-M910 - Page 2

IMPORTANT 1
The lightning flash with arrowhead, within an equi-
lateral triangle, is intended to alert the user of the
presence of uninsulated “dangerous voltage” within
the product's enclosure that may be of sufficient
magnitude to c tute a risk of electric shock to
persons
IMPORTANT 2
If the apparatus is fitted with AC mains power out-
let{s), see REAR PANEL FACILITIES for convenient
connection of additional Hi-Fi component(s}. Make
all connections ta the AC outlet(s) and the signai
terminals first, Connect the plug to the wall socket
last, make sure that the power switch is off. Discon-
nect the wail plug when the equipment is not in
(regular) use, e.g. when on vacation
READ INSTRUCTIONS — All the safety and operating
instructions should be read before the appliance
is operated.
RETAIN INSTRUCTIONS — The operating instructions
should be retained for future reference
HEED WARNING — All warnings on the appliance and
in the operating instructions should be adhered to
FOLLOW INSTRUCTIONS — Ai! operating and use in-
structions should be followed.
WATER AND MOISTURE — The appliance should not
be used near water — for example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet
basement, or near a swimming pool, etc.
LOCATION — The appliance should be instalied in a
stable location.
WALL OR CEILING MOUNTING — The appliance
should not be mounted to 4 wall or ceiling
VENTILATION — The appliance should be situated so
that its location or position does not interfere with
its proper ventilation, For example, the appliance
should not be situated on a bed, sofa, rug, or'simi-
far surface that may block the ventilation open-
ings;
or,
placed
in
built-in
installation,
such
as
a
baokease
or
cabinet
that
may
impede
the
flow
of air through the ventilation openings.
HEAT
—
The
appliance
should
be
situated
away
from
heat
sources
such
as
radiators,
heat
registers,
stoves,
or
other
appliances
(including
amplifiers)
that
produce
heat...
POWER SOURCES THe apaliance should be con-
nected to a power supply only of the type
described in the operating instructions or as
marked on the appliance.
POWER-CORD
PROTECTION
—
Power-supply
cords
should
be
routed
so
that
they
are
not
likely
to
be
walked
on
or
pinched
by
items
placed
upon
or
against
them,
paying
particular
attention
to
cords
at
plugs.
convenience
receptacles,
and
the
point
where
they
exit
from
the
appliance.
POLARIZATION
--
if
your
purchased
product
is
provid-
od
with
a
polarized
power
plug,
please
read
the
fol-
towing
instrucbons
This
product
is
equipped
with
a
polarized
altenating
current
tine
plug
(@
plug
hav-
ing
one
wader
than
the
other},
This
plug
will
tit
into
the
power
outlet
onty
one
way.
This
is
a
satety
feature.
H
you
are
unable
to
insert
the
plug
tully
into
the
outiet,
try
reversing
the
plug.
if
the
plug
should
sult
fait
to
fst,
coptact
your
electrician
to
replace
your
obsolete
outlet,
Do
nat
defeat
the
safety
purpose
of
the
p:
CLEANING ~ The applian
with a pokshing cloth
clean with
°RBLIOZ>
CAUTION
RISK OF ELECTRIC SHOCK
DO:NOT OPEN
CAUTION
TO PREVENT THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK}. NO
USER-SERVICEASLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
The exclamation point within an equitateral triangle is
intended to alert the user of the presence of important
operating and maintenant 1g} instructions in
the literature accompanying the appliance
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in accor-*
dance with the following cade.
Biue: Neutra!
Brown: Live
SAFETY
INSTRUCTIONS
POWER LINES — An outdoor antenna should be
located away from power lines
NONUSE PERIODS — The power cord of the appliance
should be unplugged from the outlet when left
unused for a fong period of time.
OBJECT AND LIQUID ENTRY — Care should be taken
80 that objects do not fall and liquids are not spilled
into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The appliance
should be serviced by 3 Pioneer authorized service
center or qualified service personnel when:
The power-supply cord or the plug has been
damaged; or
Objects have fallen, or liquid has been spilled into
the appliance: or
The appliance has been exposed to rain: or
The appliance does not appear to operate normally
or exhibits 3 marked change in performance: or
The appliance has been dropped; or the enclosure
damaged.
SERVICING — The user shouid not attempt to service
the appliance beyond that described in the oper-
ating instructions. For all othér servicing, contact
the nearest Pioneer authorized service center
@® @€@ @ @
POWER LINES
SERVICE
ENTRANCE
CONDUCTORS +
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
marking identifying the terminals in your plug pro:
as follows:
The wire which is coloured blue must be connected zo
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L ar
coloured red.
Equipment sold in the U.K. is not supplied with
a power plug.
eed
OUTDOOR ANTENNA GROUNDING
antenna is connected tu the antenna terminal, be
sure the antenna systemtis grounded so as to pro-
vide some protectian against voltage surges and
built up static charges
In the U.S.A, section 810 of the National Electri-
cal Code, ANSUNFPA No 70 1884, provides
information with ‘espect to praper grounding of
the mast and supporting structure. grounding of
the lead-in wire to an antenna discharge unit, size
of grounding cansuctors, location of antenna dis-
charge unit, connection to grounding electrodes,
and requirements for the groundir it
Fig. A.
CART — An appliance and cart
moved with care. Quick stops, excessive force,
and uneven surfaces may cause the appliance and
cart Combination to ov
if an outside
combination should be
sure
4mm?) epp-
per, No 8 AWG 18.4 mm} atumi-
nue No 1? AWG (1.0 mm)
steel, bronze wire, or
ind
ire,
lead-in and
se with stand-
off insulators spaced from 4 feet
(1.22 meters) to 6 feet (1.83
apart.
cc) Mount antenna discharge unit as
closely ble to where fead
in ents
Use iv
b}
cure any
ground wires to hy
STAND-OFF
INSULATORS 0
ANTENNA,
LEAD-IN
WIRE
TOEXTERNAL = dj
ANTENNA
TERMINALS OF
PRODUCT
2 not staller thas
AWG 119.3 mm4) copper. c
equivalent, when a separ
a
- | GROUNG antenna-grounding electrode ts.
WIRE ae ANTENNA
4
SROUND
DISCHARGE
used
ion
FG
SERVICE
ENTRANCE
CLAMPS
UNIT
¢
ton
B1G-24
yl
EQUIPMENT ‘sien
WERE ad.
POWER SERVICE
GROUNDING ELECTRODE SYSTEM
fe.g. interior metal water nigel
GROQUNDIN:
iNT Tae
FIG.A cy
OPTIONAL ANTE
DRIVEN 8 FELT
PAPS