PDP-425CMX
71
5678
56
7
8
C
D
F
A
B
E
2-2. Factory shipment setting (Initial setting)
(1) Press the [CLEAR] or [ID SELECT] key to select the [FUNCTION] menu.
(2) Move the POSITION/CONTROL keys of [ ] and [ ] to the item of [SHIP]. Then, move the 5
2 3
∞
5
∞
POSITION/CONTROL keysof [ ] and [ ] to select [DESTINATION ALPHABETS] shown below.
(The asterisks * shown below denote the numerals or the characters.)
A/J : PDP-425CMX/LUC5
G : PDP-42MXE10/LDFK5
CKD : PDP-42MXE10/YVXK5
(3) Press the keys in the order of [MUTE]→POSITION/CONTROL [ ] → POSITION/CONTROL
[ ] →[MUTE] to make "Factory shipment setting". When "Factory shipment setting" is
executed, the red characters of [SET] is shown for about 5 seconds on the right side of the
[DESTINATION ALPHABETS]. The setting is finished when these red characters of [SET] go out. In
regard to the factory shipment setting values, refer to the descriptions given below.
FUNCTION
SCART OFF SAFEL MODE ---
SHIP A PLE TEST OFF --
LIMIT-VD OFF
LIMIT-PC ON
GAMMA MD
12
VOL OFFSET
2
PSC-T OFF ROTATEPTN 1
EXT-PC OFF
[MENU/ENTER] NEXT [EXIT] PREV 10/10
FUNCTION
SCART
SHIP
LIMIT-VD
LIMIT-PC
GAMMA MD
VOL OFFSET
PSC-T
EXT-PC
OFF
A
OFF
ON
10
2
OFF
OFF
SAFEL MODE
PLE TEST OFF
ROTATE PTN
---
---
1
[MENU/ENTER] NEXT [EXIT] PREV 10/10
SET
Press the keys of the remote control in the order of [PIP SHIFT] → [SET] → [CLEAR] → [PIP SHIFT]
in order to withdraw from the Factory shipment setting.
(4)
To Next Page
Loading...
Need help?
General