Pioneer PDP-435PE

PDP-435PE
48
1234
1234
C
D
F
A
B
E
6.3 COMMAND
6.3.1 RS232C COMMAND
• The panel control items for the PDP-435P system can be controlled with the RS-232C commands by connecting a PC through the
GGF1475 special communication device when the Media Receiver is not connected with the PDP.
Note: The special communication device for the PDP-503P cannot be used with this unit, because the control lines within the MDR cable are
different.
Connection
GGF1475 special
communication device
MDR
D-SUB 9-pin straight cable
PC for control
Connect to the D-SUB 9-pin connector.
Communication line:
Connect the system cable.