Pioneer PDP-436RXE

19
En
Watching TV
06
English
Changing channels
Using P +/P – on the remote control unit
•Press P + to increase the channel number.
•Press P – to decrease the channel number.
When viewing Teletext information:
•Press P + to increase the page number.
•Press P – to decrease the page number.
For Teletext, see “Using the Teletext Functions” on pages 41
and 42.
NOTE
• CHANNEL +/– on the Plasma Display operates the same as
P +/P –.
• P +/P – cannot pick up channels that are set to skip. For
Channel Skip, see steps 13 and 14 under “Using Manual
Adjust” (page 25).
Using 0 – 9 on the remote control unit
Select channels directly by pressing buttons 0 to 9.
EXAMPLE
• To select channel 2 (1-digit channel), press 2.
• To select channel 12 (2-digit channel), press 1 then 2.
When viewing Teletext information:
View a page directly which is 3-digit page number from 100 to
899 by pressing buttons 0 to 9. See page 41.
NOTE
• In the standby mode, when you press 0, the power turns on
and images come from the INPUT 1 source. Or, when you
press any button from 1 to 9, TV images display.
(front view)
CHANNEL +/–
8
AAA
STEREO
10:00
STANDARD
FULL
Channel display