123
KEY LOCK/UNLOCK
5.7 KEY LOCK/UNLOCK
5.7.1 Functions
The KEY LOCK function disables the remote control unit and the main unit operation panel, preventing unauthorized
persons from tampering with the unit after installation (RS-232C commands remain effective). Attempting to operate
the remote control unit or the main unit operation panel will cause “KEY LOCK” to be displayed in the upper right
corner of the screen. The unit is factory preset to KEY UNLOCK, meaning that the remote control unit and main unit
operation panel are both enabled.
5.7.2 How to switch KEY LOCK/UNLOCK
Two settings methods are available:
1) With the operating panel of the main unit (A hidden button is provided for this purpose.)
Change the setting between KEY LOCK and KEY UNLOCK using the KEY LOCK/UNLOCK button hidden between
the STANDBY/ON and INPUT buttons. Pressing the KEY LOCK/UNLOCK button while in menu mode or integrator
mode automatically places the unit in normal operating mode and at the same time invokes the KEY LOCK status.
2) Using RS-232C Commands
Issue the <AJY> command to enter RS-232C adjustment mode. Then issue the <KLY> command to invoke KEY
LOCK or the <KLN> command to invoke KEY UNLOCK.
To Previous Page
Loading...
Need help?
General