Need help?Do you have a question about the Pioneer SX-400L and is the answer not in the manual?
Power Output| continuous average power output | 20 watts |
|---|---|
| continuous power output at 1kHz (both channel driven) | 22 watts per channel |
| total harmonic distortion (40 Hertz to 20,000 Hertz, 8 ohms, from TAPE) | 10 watts per channel power output |
Frequency Response| phono (RIAA equalization) | 30Hz to 15, 000Hz + 0.5dB |
|---|---|
| tape/adaptor play | 15Hz to 60, 000Hz + 3dB |
| tone control bass | +8dB (100Hz) |
Dimensions and Weight| dimensions | 420(W) x 94(H) x 310(D) mm |
|---|---|
| dimensions (inches) | 16-9/16(W) x 3-11/16(H) x 12-3/16(D) in |
| weight (without package) | 5.5kg (12lb 20z) |
Step-by-step guide for preparing and connecting speaker cords to terminals.
Important notes on polarity and impedance when connecting speakers to the system.
Information on the receiver's switched and unswitched AC power outlets.
Description of all buttons, knobs, and indicators on the receiver's front panel.
Guide to connecting and operating tape decks or adaptor units for playback and recording.
Details on connecting FM antennas using coaxial or twinlead cables.
Instructions for properly grounding FM antenna installations for safety.
Guidance on connecting indoor and outdoor AM antennas for better reception.
Steps to diagnose and resolve issues when no sound is produced by the receiver.
Solutions for occasional unwanted noise or howling sounds during audio playback.
Troubleshooting tips for poor or absent stereo signal reception.
Detailed technical specifications for audio output, tuner sensitivity, and selectivity.
Information on power requirements, dimensions, weight, and included accessories.
To Next Page
