Need help?Do you have a question about the Pioneer SX-434 and is the answer not in the manual?
General| Frequency Response | 20Hz to 20kHz |
|---|---|
| Damping Factor | 30 |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Tuning Range | FM, MW |
| Output Impedance | Unknown |
| Power Output | 15 watts per channel into 8Ω (stereo) |
| Signal to Noise Ratio | 70dB (MM) |
| Output | Headphone |
| Semiconductors | 2 x IC |
| Weight | 19.8 lbs (9 kg) |
Instructions on how to change the line voltage setting and select the correct fuse rating.
Guidance on how to replace a blown fuse with a new one, referencing Fig. C.
How to connect speaker systems to the receiver's A and B speaker output terminals.
Instructions for connecting FM antennas, including T-type, outdoor, and coaxial cables.
Importance and method of installing a ground wire for safety and interference reduction.
Step-by-step guide for tuning and enjoying FM broadcasts.
Step-by-step guide for tuning and enjoying AM broadcasts.
Common noise issues during radio reception and their suggested remedies.
Problems encountered during record playback, such as hum or poor tone quality, and fixes.
Troubleshooting power-on failures, lack of speaker sound, or howling during playback.
To Next Page
