Need help?Do you have a question about the Pioneer SX-737 and is the answer not in the manual?
General| Power Output | 35 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency Response | 10Hz to 100kHz |
| Total Harmonic Distortion | 0.5% |
| Tuning Range | FM, MW |
| Damping Factor | 40 |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Output | 150mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Channel Separation | 55dB (line) |
| Semiconductors | 3 x FET |
Details on the FM tuner's high stability circuitry, dual gate MOS FET, and phase-linear ceramic filters for superior performance.
Explains the use of reliable silicon power transistors and differential circuitry for stable output and improved frequency characteristics.
Describes the electronic circuitry and relays that protect speakers and transistors from damage due to faults.
Instructions for adjusting the line voltage selector and replacing the fuse for different power requirements.
Instructions for connecting speaker systems to the receiver's A and B terminals, including polarity and impedance notes.
Instructions for connecting FM antennas, including T-type and coaxial cable options for best reception.
How to connect a turntable to the PHONO input jacks and the ground terminal.
Connecting tape decks to TAPE REC and TAPE PB jacks for recording and playback operations.
Controls for selecting recording sources and monitoring tape playback or recording progress.
Lists crucial control and switch adjustments required before switching on the receiver for safe operation.
Explains the receiver's protection circuit and troubleshooting steps for delayed or absent sound.
Diagnosing and resolving continuous noise, hum, or static during FM/AM broadcasts.
To Next Page
