Do you have a question about the Pioneer SX-D7000 and is the answer not in the manual?
Tuning Range | FM, MW |
---|---|
Speaker Load Impedance | 4 - 16 ohms |
Power Output | 100 W per channel (8 ohms) |
Input Sensitivity | 2.5mV (MM), 150mV (line) |
Output | 150mV (line) |
Explains the two scanning methods and frequency stability of the tuner.
Details the amplifier's high-speed bias servo circuit and output power.
Describes the tone amplifier's low distortion and precise RIAA equalization.
Details how to connect speakers, including polarity and impedance.
Important warnings and guidelines for safe and proper speaker connection.
Guide for connecting turntables, including ground lead and MC/MM cartridges.
Instructions for connecting tape decks for recording and playback.
Methods for connecting FM antennas using coaxial or twin-lead feeders.
How to position the built-in bar antenna or set up external AM antennas.
Safety and noise reduction guidelines for proper grounding.
Function selector, tape monitor, and adaptor switches for source management.
Station call switches, memory, and tuning mode/direction controls.
Essential setup before power-on and methods for tuning broadcasts.
Details power output, distortion, frequency response, and input/output specs.
Covers input sensitivity, RIAA equalization, and tone control specs.
Lists sensitivity, quieting, signal-to-noise, distortion, and selectivity for FM tuning.