Listening to your system06
36
En
Using the surround back channel
(Extended mode)
VSX-515 model only
• Default setting:
EXT. ON
You can have the receiver automatically use 6.1
decoding for 6.1 encoded sources (for
example, Dolby Digital EX or DTS-ES), or you
can choose to always use 6.1 decoding (for
example, with 5.1 encoded material). With 5.1
encoded sources, a surround back channel
will be generated, but the material may sound
better in the 5.1 format for which it was origi-
nally encoded (in which case, you can simply
switch the Extended mode off).
1
• Press
EXTENDED MODE
(front panel) to
select a surround back channel option.
Each press cycles through the options as
follows:
•
EXT. ON
– 6.1 decoding is always used (for
example, a surround back channel will be
generated for 5.1 encoded material)
•
EXT. AUTO
– Automatically switches to 6.1
decoding for 6.1 encoded sources (for
example, Dolby Digital EX or DTS-ES)
•
EXT. OFF
– Maximum 5.1 playback
Note
1• You can’t use the surround back channel with headphones, the
STEREO
/
DIRECT
mode, the
AUTO SURR.
mode, or if the
surround back speaker is set to
NO
in
Speaker setting
on page 48.
• You can’t hear the surround back channel with DTS 96kHz/24 bit or PCM 96 kHz sources.
Type of source
Extended
mode
Standard
Advanced
surround
Multichannel
sources
Stereo sources
2
Pro Logic
II x
2
Pro Logic
Neo:6
Dolby Digital EX/
DTS-ES/WMA9 Pro
encoded multi-
channel source with
6.1/7.1ch surround
ON
*
AUTO
*
Dolby Digital/DTS/
WMA9 Pro encoded
multichannel source
ON
*
AUTO
*
Dolby Digital/WMA9
Pro/DTS encoded
stereo source; other
digital stereo source
ON
*
AUTO
*
Analog 2-channel
(stereo) source
ON
AUTO
* Excluding WMA9 Pro format
VSX_415-515.fm 36 ページ ２００５年１月２１日 金曜日 午後５時３分
To Next Page
Loading...
Need help?
General
