USER’S GUIDE — 13
Defines the Pipe Material. (Steel, Stainless Steel,
Brass, Aluminum, Cast Iron, PVC or Copper).
Elbow Type – Defines the type of radius (long or
short) and whether a factory or field cut 45˚ Butt
Weld elbow is being used. Default value is Butt
Weld – Long.
Enters the nominal Pipe Size and provides data
pertaining to the entered size.
Pipe Type – Defines the Pipe Type based on Pipe
Material.
Cutback – Calculates pipe Cutback after Bend
Angle and Offset are entered.
Rolling Offset (Roll)– Calculates Rolling Offset
pipe length.
Flow – Enter or calculate volumetric Flow Rate
through a pipe.
Velocity – Enter or calculate Velocity and convert
between feet per second, feet per minute, and me-
ters per second.
Pressure – Enter Pressure value. Calculate Pres-
sure loss. Convert between units of pressure.
Force – Enter or calculate Force and convert be-
tween lbf, newton.
Area – Enter pipe area for use in Flow, Velocity,
Pressure, and Force calculations. Calculate Area
given values for Flow/Velocity or Force/Pressure.
To Next Page
Loading...